Stihl MH 710 Notice D'emploi page 10

English
6.2 Attaching and Removing the
Running Wheels
6.2.1 Attaching the Running Wheels
► Stop the engine.
► Place axle mount (1) on rubber tyre (2) so the
bores align.
► Insert bolts (3).
► Place washers (4) and spring washers (5) on
bolts (3).
► Screw on nuts (6) and tighten firmly.
► Push running wheels (7) onto drive shaft (8)
so the bores align.
► Push folding retainers (9) through the bores in
drive shaft (8) and close the securing clips.
Running wheels (7) are secured.
6.2.2 Removing the Running Wheels
► Stop the engine.
► Pull out the folding retainers.
► Remove the running wheels.
► Push the folding retainers through the bores in
the drive shaft.
The folding retainers are kept in place.
10
6.3 Fitting and Removing the
Wheels
6.3.1 Attaching the Front Wheel
NOTICE
■ The front wheel is only used for transport and
must be removed again for working.
► Stop the engine.
► Slide front wheel (1) into frame (2) so the
bores align.
► Insert pin (3) through the bore.
► Push retaining pin (4) through the bore in
pin (3).
Pin (3) is secured and front wheel (1) is locked
in position.
6.3.2 Removing the Front Wheel
► Stop the engine.
► Detach retaining pin (4) and remove pin (3).
► Pull front wheel (1) out of frame (2).
► Push pin (3) through the bore in front
wheel (1) and secure using retaining pin (4).
Pin (3) and retaining pin (4) are secured.
► Store the front wheel safely.
6 Assembling the Cultivator
0478-404-9905-C