Cleanmaxx AC-1107-3 Mode D'emploi page 26

Masquer les pouces Voir aussi pour AC-1107-3:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
Cleaning the exhaust fi lter
The device has two exhaust fi lters
One exhaust fi lter is located in the compartment on the rear side of the vacuum
cleaner (see chapter "Product contents and device overview", section "Rear view").
4. If necessary, rinse out the exhaust fi lter thoroughly with clean, lukewarm water.
ATTENTION: Do not in any case clean the fi lter in the washing machine or
dishwasher! Then shake off any remaining water and let the fi lter air dry completely
before reinstalling it.
5. Once all parts are dry, place the exhaust fi lter back into the fi lter compartment.
6. Fit the compartment cover again and press it down until it engages audibly.
The other exhaust fi lter is located beneath the dust container.
4. If necessary, rinse out the exhaust fi lter thoroughly with clean, lukewarm water.
ATTENTION: Do not in any case clean the fi lter in the washing machine or
dishwasher! Then shake off any remaining water and let the fi lter air dry completely
before reinstalling it.
Cleaning turbo nozzle
Cleaning the animal hair fl oor nozzle
26
1. Press the catch toward the compartment cover and remo-
ve the cover.
2. Remove the exhaust fi lter from the compartment.
3. Tap the exhaust fi lter out over a garbage bin and brush
off any loose dirt. If necessary, wipe out the compartment
with a damp cloth.
1. Push the release button on the dust bin and pull it out of
the device by the handle.
2. Remove the exhaust fi lter from the compartment.
3. Tap the exhaust fi lter out over a garbage bin and brush
off any loose dirt. If necessary, wipe out the compartment
with a damp cloth.
1. To make it easy to clean the turbo nozzle, you can open
the nozzle: To do this, twist the ring on the end piece of the
nozzle anticlockwise.
2. Carefully take off the top housing part. Now you can
remove hair, dust etc. from the brush.
3. After cleaning, put the nozzle back together again and turn
the ring in the clockwise direction until it clicks audibly into
place.
1. Open the cover by pushing the two release buttons on
both sides of the cover and fl ip it open.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Z 07338

Table des Matières