Part Names And Function - Denon DN-HC4500 Mode D'emploi

3 PART NAMES AND FUNCTION

(1) Side Panel
q
q
Analog out put terminal (LINE OUT)
• This is unbalanced RCA output terminals.
• Audio signals outputs.
w
DRIVE terminal
• Connect the DN-D4000/D4500/BU4500 drive
unit.
For instructions on operating the DN-D4000/
D4500/BU4500, refer to the respective
model's operating instructions.
e
USB B terminal
• Connect to a computer.
• Sends the USB MIDI and HID commands
from the DN-HC4500.
• Sends the USB audio signals from a PC.
u y
w e r t
r
POWER button
• Push this button to turn power on and off.
t
AC Inlet terminal
• Inlet the power cord's plug into DN-HC4500's
AC inlet terminal.
y
Fader start terminals
• Use this when your mixer has the Fader Start
function.
u
X-CONROL output terminal
• Use this when connected to a DENON DN-
X900 or DN-X500 mixer that offers X-Control.
• With the DN-HC4500 it is possible to convert
the input fader position into a MIDI signal and
send it from the USB terminal.
(2) Front panel
#3
i !0 !2
o !1 !3 !5
CAUTION:
Note that there are many buttons working two different function selected by short time pushing or
long pushing (1second or more). The "
indicates long time push function.
i
TIME, Total
[When PCDJ connected]
Refer to the PCDJ's manual.
[When DN-D4500 connected]
• TIME:
When this button is pressed, the time
indicator switches between "ELAPSED"
(elapsed time), "REMAIN" (remaining time).
• Total:
When this button is pushed for more 1
second, you can display the total time.
o
FLIP/B TRIM
[When PCDJ connected]
Refer to the PCDJ's manual.
[When DN-D4500 connected]
• Push this button to switch between the loop
mode/hot start mode and stutter mode.
• After setting the B point, the B TRIM MODE
can be selected.
3
ENGLISH
#2 #1 #0 @9 @8 @7 @6 @5 @4
!4 !6 !8 !9 @0 @1 @2 @3
!7
" mark indicates short time push function and "
!0
MEMO, PRESET
[When PCDJ connected]
Refer to the PCDJ's manual.
[When DN-D4500 connected]
• MEMO:
The MEMO mode starts when this button is
pushed once in the Cue/Pause mode.
• PRESET:
When this button is pushed for more than 1
sec, the PRESET mode menu is displayed.
!1
CUE/STUTTER
[When PCDJ connected],
[When DN-D4500 connected]
• Pushing this button in play mode will force
the file back to the position which playback
started.
• In Cue mode, by pushing the CUE button
makes a Stutter sound from the Cue point.
This is called Stutter play. (Stutter)
ENGLISH
" mark