Basic Operation - Denon DN-HC4500 Mode D'emploi

ENGLISH

5 BASIC OPERATION

This section describes the basic operations when connected to a DN-D4000/D4500/BU4500.
PLAY and PAUSE
• Each push of the
PLAY/PAUSE button switches
between playback and pause.
PLAY/PAUSE button
illuminates solid green during
playback and flashes in pause.
• When the PLAY/PAUSE button is pushed during
play, the DN-D4500 pauses playback at that
point. Push PLAY/PAUSE button once again and
playback resumes.
PLAY and Cue
• When the CUE button is
pushed during playback, the
track/file stops and returns to
the original position of which
playback started from, the
(Cue point). This function is also called Back-Cue.
With the Back-Cue function, you can start from
exactly same position.
The CUE button illuminates solid red when DN-
D4000/D4500/BU4500 is ready to start playback.
• You can set and change Cue point as follows.
• When you started playback.
• File select finished.
• Manual search.
Select the File
• Turn the PARAMETERS knob.
Adjusting the pitch
With Pitch slider you can adjust the playback speed
(Pitch).
Push the PITCH button to
light the PITCH LED.
1
Pitch decreases
Move the Pitch Slider to adjust
the pitch.
2
The current pitch setting is
displayed on the display.
Pitch increases
The DN-D4000/D4500/BU4500 has several
pitch ranges.
When the RANGE button
is pushed for more than 1
sec, the pitch range can
be selected with the
3
PARAMETERS knob.
• When the PARAMETERS
knob is pushed the pitch
range is entered and the
pitch range selection
mode is cancelled.
Pitch Bend
With PITCH BEND function you can change pitch
temporary. DN-D4000/D4500/BU4500 has two
ways for this function PITCH BEND buttons and
JOG disc.
[PITCH BEND +/– buttons]
• Push the PITCH BEND
button for momentary
change of pitch.
1
While holding these
buttons down, the pitch
continues to change up to the limitation.
• After releasing the PITCH BEND buttons,
playback pitch returns to slider setting.
[JOG disc]
• The playback speed can
2
be changed by turning
JOG disc during
playback.
Power on play
When the DN-D4000/D4500/BU4500's
"Power On Play" presetting is set to "ON",
1
playback starts from the beginning of the
disc when the power is turned on.
Relay playback
For instructions on relay playback, refer to the
manual of the DN-D4000/D4500/BU4500.
6
ENGLISH