Denon DN-HC4500 Mode D'emploi page 17

Press the Execute button to begin updating
the version.
Once version updating is completed,
"Version up was completed." is displayed.
6
The following is displayed on the device's
panel during version updating:
On Deck1:
Once version updating is completed:
If version updating has failed, "Version up
was not completed." is displayed and the
screen returns to as it was before the
Execute button was pressed. Press the
Execute button again.
Press the OK button to finish.
The following is displayed on the device's
panel:
On Deck2:
7
Quit the updating program and turn off the
DN-HC4500's power.
NOTE:
• Do not turn off the set's power or disconnect
the cable connecting it to the computer during
loading or version updating. Also, do not press
any buttons on the set or any keys on the
computer's keyboard.
• If an error message appears during loading or
version updating, repeat from step 1.
Other error messages are as follows:
"File is invalid"
When the loaded update file was invalid.
"Load failed. Check the connection, and retry"
When a transfer error has occurred during
transfer of the update file to the device.
"Loaded data is invalid. Check the file."
When a SUM check error has occurred after
transfer of the update file to the device.
"Version up was not completed."
When version updating was not completed
normally.
13
ENGLISH
ENGLISH