Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
by material defect or manufacturing defect. Original
32
payment voucher with the sales date needs to be
submitted for any claim in the guarantee period.
The guarantee does not cover any unauthorised
use such as appliance overloading, use of violence,
damage as a result of any unauthorised interference
or caused by foreign items. Failing to follow the ope-
rating and assembly instructions and common wear
are also not included in the guarantee.
Service
Do you have any technical questions? Any claim? Do
you need any spare parts or operating instructions?
We will quickly help you and without needles bureau-
cracy at our web pages at www.guede.com in the
Servicing part. Please help us be able to help you. In
order to identify your device in case of claim we need
the serial No., product No. and year of production. All
this data can be found on the type label.
Serial No.:
Failure removal
Issue
Wire not feeding despite wire
feed pulley turning.
Interrupted or disruptive wire
supply
Electric arc turned o
Porous welded joint
Welder suddenly stops working
after longer operation
Art. No:
Year of production:
Important information for the
customer
Please note that returns within or outside the warran-
ty period should always be in the original packaging.
This measure e ectively avoids unnecessary transport
damage and any associated disputed ruling. Your
equipment is optimally protected only in the original
box, and keeping it in that box will ensure smooth
processing.
Causes
Dirty current nozzle
Coil carrier clutch set too tight.
Damaged hose bundle
Too low clamping pressure of the
wire feed pulley
Damaged current nozzle
Burnt current nozzle
Dirty driving gear nozzle
Cut on worn driving gear
Poor contact between earth pliers
and the respective part
Short circuit between current
nozzle and gas supply pipe
Too loose current nozzle
Wrong distance of inclination of
the hose bundle
No gas, too little gas or incorrect
gas
Welder has overheated due to too
long use and the thermal protec-
tion has activated
Removal
Clean
Loosen
Check the wire guide housing
Increase the clamping pressure
Replace
Replace
Clean
Replace
Tighten the pliers and check them
Remove paint and rust
Clean or replace contact tip and
gas jet
Current nozzle without dirt, paint
and rust remains
Tighten the current nozzle rmly
Distance between the hose bundle
and the respective part must be
5-10 mm. Inclination must not be
lower than 60 with respect to the
part.
Add (more) gas or change gas
Let the welder cool down
Publicité
