Güde MIG 190 KOMBI Traduction Du Mode D'emploi D'origine page 32

ENGLISH
28
Work with an exhaust system or in well ventilated
spaces.
Long-term inhalation of welding gases may be harm-
ful to your health.
Avoid direct inhalation of gases.
Ensure that there are no persons who are not wearing
protective clothing and eye protection within a range
of 15 m of the arc. Protect yourself and any persons
who are nearby against the possible hazards caused
by the arc!
WARNING! Risk of injury Improper
handling may lead to serious injuries!
Leave the cable assembly tip and workpiece to cool
down after operation.
Long-term working with the appliance may damage
hearing. Hearing protection to be used at all times.
Make sure the welding smoke is exhausted or the
place of welding ventilated well.
Caution! Risk of accidents due to splashing
slag particles
The slag becomes hard and brittle after it has soli-
di ed. The slag hammer is then used to break the
slag up into small pieces with sharp edges, which
is associated with a risk of eye injuries.
Therefore, ensure that your eyes are protected
with suitable safety goggles when removing the
slag.
Burning slag and sparks may cause res and explosi-
ons. The device must never be used in a ammable
environment.
Caution! Risk of beams and burns
• At the workstation, it is important to make refe-
rence to the risk of eye injury with a sign which
reads "Caution – do not look into the ames!".
• The workstations should be shielded o as much
as possible to protect people who are nearby.
• Unauthorised persons must not be involved with
the welding work.
• In xed workstations which are nearby, the walls
should not be painted in a light colour and should
not be shiny.
• Windows must be protected against light shing
through or re ecting beams up to at least head
height, e.g. using suitable paint.
Keep the welding device, the mains plug and the
power cable away from open ames and hot surfaces.
Do not weld on containers, vessels or pipes which
have contained ammable liquid or gases.
Wood, sawdust, „varnishes", petrol, kerosine, natural
gas, acetylene, propane and similar ammable
materials must be removed from the place of work
and the surrounding area or protected against sparks
ying away.
Caution! Fire hazard due to spraying
sparks
If the molten or burning metal or slag particles
land on ammable substances, these may ignite
and cause a re. Therefore, remove all ammable
objects from your workspace before commencing
welding work. Keep a suitable re extinguisher
to hand.
In this regard, take the following materials into
consideration in particular:
• Paper
• Rags
• Textiles
• Wood and wood bres
• Rubber
• Plastic
• Petrol
• Oils
• Tar-like substances
• Paints and solvents
No welding or cutting on vessels and pipes if they
are open, containing materials able to explode due
to heat or moisture or able to cause other dangerous
reactions.
Caution! Explosion hazard and re hazard
due to welding sparks
Both the welding sparks and the welding point
itself, which is heated to high temperatures, may
cause explosions. Therefore, do not use the device
in a potentially explosive environment where
substances such as ammable liquids, gases and
paint mist are present.
Please note:
• When the welding device is in operation, do not
place the burner on the welding device itself nor
on any other electrical device.
• Before nishing your welding work, do not touch
the contact tip itself nor any other metal objects
which touch the contact tip.
• Disconnect the power supply to the device im-
mediately after completing your welding work.
• It is essential to ensure that no cables become
wrapped around your body.
• It is essential to ensure that you are not within
the welding circuit. The burner and earth must
always be on the same side.