Assembling Instructions; Assembling The Handle Bar; Mounting And Emptying The Collection Bag; Operation - Grizzly ERV 1801-37 ZV Traduction De La Notice D'utilisation Originale

GB

Assembling instructions

Prior to any work on the implement
always disconnect the plug from
the power socket!
Ensure during assembly that the
power cable is not squeezed and
that it has sufficient play.

Assembling the handle bar

1. Attach the lower bar (6) to the
B
appliance housing (8) and
fasten it using the two quick-
release levers and washers (7).
The smooth side of the washer
should point towards the quick-
release lever; the grooved side
should point towards the device.
2. Screw both central bars (5) with
the screws, quick-release levers
and washers (4) to the lower
bar (6). The smooth side of the
washer should point towards the
quick-release lever; the grooved
side should point towards the
device.
3. Suspend the mains cable strain
relief (14) from the upper han-
dlebar (3).
4. Screw the upper handlebar (3)
with the screws, quick-release
levers and washers (4) to both
central bars (5) to fasten.
5. Fasten the machine cable (15)
to the bar using the machine
cable terminals (11).
Mounting and emptying the
collection bag
WARNING: Never operate the
implement without the impact
protector. Danger of Injury!
28
The collection bag is only intended
for operation with the aerator cylin-
der ( 16).
A
C 1. Pull the collection bag over the
rods.
2. Put the plastic straps of the col-
lection bag over the collection
bag rods and clip into the plastic
straps.
Mounting the collection bag on the im-
plement:
3. Lift the impact protector (13).
4. Push the pins on the collection
bag rods into the socket in the
implement case.
5. Release the impact protector so
that it holds the collection bag
(12) in its position.
Removing and emptying the collection
bag:
6. Lift the impact protector (13)
and take out the collection bag
(12).

Operation

Please observe local regulations
concerning noise protection.

Setting the working positions

The implement has 5 principal position
settings:
+10 mm: Transport position
This position sets the maximum safety
spacing between the tool and the floor.
-3 mm: Working position
Set this position when working with a new
implement.