R In S I Ng The Mach Ine - SOLIS 1018 Mode D'emploi

C. R IN S I NG THE MACH INE
In order to rinse the inside of the machine, you should let a tank full of water run
●
through the machine before the initial startup. Proceed as follows:
1. After the Solis water filter has been installed in the water tank, insert the full
water tank into the machine.
Tip: You can also leave the water tank in the appliance during subsequent fillings
and refill it with water from above. Remember that the appliance must be discon-
nected from the power supply, i.e. the power plug must be disconnected. Also
make sure to pour the water only into the tank. Spilled water has to be wiped
GB
away with a towel immediately.
2. Plug the power plug into a suitable power socket. The steam/hot water control
must be in the central position
3. Screw the portafilter without the filter insert into the brewing head. The handle
of the portafilter is first positioned to the left, below the
turned to the right all the way to the stop below the
;
4. Press the On/Off button , the function light in the button starts to flash. Once
the operating temperature is reached, the function lights of all four buttons
;
( and , , ) will light up constantly.
NOTE: During the heating-up phase, approx. 60 ml of hot water are discharged
through the portafilter resp. the brewing head! Make sure that you do not hold your
hands or other parts of your body or heat-sensitive or water-sensitive objects under
the brewing head during this time. This rinsing process starts only if the appliance
was allowed to cool down entirely. If the appliance is still slightly warm, the rinsing
cycle is automatically skipped.
NOTE: Always make sure that the steam/hot water control is in the central posi-

tion , otherwise the appliance will not heat up. In this case, the function light of
the On/Off button flashes quickly.
Note: When the hydraulic circuit of the appliance is empty, all four buttons
flash simultaneously. To prepare the appliance for further use, please refer
to chapter "Water tank runs empty during use" on page 155.
5. Place the supplied milk jug under the portafilter, on the drip tray.
146

.
symbol, and is then
symbol.
6. Press the button. Wait for water to run through the portafilter and then
for the water flow to stop.
7. Place the empty milk jug under the steam / hot water wand.
8. Turn the steam / hot water control to the right, to the hot water function
9. Wait for hot water to run through the steam / hot water wand. Stop the hot wa-
ter function by returning the steam / hot water control to the central position
10. Repeat steps 5 through 9 until the water in the water tank is used up.
Now, your appliance is ready for use.
NOTE: Always rinse your machine as described if your appliance was not in use for
a couple of days. The water tank is empty of water if you can hear a vibration and a
louder pumping noise. All four function lights of the buttons (
flash simultaneously. To make the appliance ready for use again, please read the
chapter "Water tank runs empty during use" on page 155.
GB
.

.
;
and , , )
147