Instruction To Use; On / Off; Mode Selection - Oceanic OCEACLIM700W9 Guide D'utilisation

UTILISATION
IMPORTANT :
- When stopping the air conditioner, wait at least 3 minutes before turning it on
again.
- In order to optimize the performance of your air conditioner, we recommend that
you do not expose it directly to sunlight during operation (if possible, pull the
curtains or close the shutters).

1. ON / OFF:

This command switches the device on or off. (Point 1)
In standby mode, the display shows the room temperature.
In operating mode, the display shows the target temperature.

2. MODE SELECTION:

Selecting one of the 3 modes (Point 2):
• Air conditioner
• Dehumidification
• Ventilation
Select the desired mode: Air conditioning, Dehumidification or Ventilation.
The corresponding indicator lights up.
a. AIR CONDITIONER Mode:
The air is cooled and the hot air is exhausted to the outside through the exhaust tube.
Adjust the fan speed according to the most comfortable air temperature.

In AIR CONDITIONING mode, the exhaust air pipe must ventilate the hot air
outside.
The cooling function turns off when the room temperature is below the set temperature.
Ventilation, however, continues to operate at the set level. The cooling function starts again
as soon as the room temperature exceeds the set temperature.
The programmed temperature can be 16 ° C and 31 ° C
b. DEHUMIDIFICATION Mode:
When the DEHUMIDIFY mode is selected, the fan speed
can not be adjusted and the sleep function can not be
selected. The fan speed is set to slow.
Only the timer function can be selected.
Note: In DEHUMIDIFICATION mode, the unit does not
need a drain hose. Keep windows and doors closed.
Continuous drainage can be achieved by connecting a
drain hose to the back of the unit.
IV.

INSTRUCTION TO USE

43