Temperature Adjustment; Ventilation Speed; Timer - Oceanic OCEACLIM700W9 Guide D'utilisation

c. VENTILATION Mode:
When the VENTILATION mode is selected, the air circulates in the room without being
cooled.
Note: In VENTILATION mode, the unit does not need a drain hose.
The temperature and sleep function can not be adjusted.
Only the timer function can be selected.
3. TEMPERATURE ADJUSTMENT CONTROL:
Used for setting the thermostat.
In the Climate mode, if you press the "UP" or "DOWN" button, the set temperature is
displayed and can be adjusted. The temperature can only be set in cooling mode.
When stopping the air conditioner, wait 3 minutes before turning it on again.
4. VENTILATION SPEED CONTROL:
In cooling and ventilation mode: 2 speeds can be set (Point 7):

F1 = slow speed

F2 = fast speed

5. TIMER:

 AUTOMATIC STOP:
When the unit is on, press the timer button (the timer indicator will light) to select the
number of hours you want the unit to operate in AIR CONDITIONING mode. The unit will
automatically stop at the end of this time.
 AUTOMATIC STARTUP:
When the unit is in standby, press the timer button to select the desired number of hours
before the unit turns on automatically in AIR CONDITIONING mode.
If the timer is programmed (even when the unit is turned off), the indicator displays the
number of hours remaining before the auto power on. The time can be set between 1 to 24
hours.
IMPORTANT
In order to optimize the performance of your air conditioner, we recommend that you do not
expose it directly to sunlight during operation (if possible, pull the curtains or close the
shutters).
6. ALARM WARNING LIGHT "TANK FULL"
The Alarm light indicates that the internal water tank needs to be
drained. The appliance does not work until the water has been
drained.
− Position a container under the cap
(1) to collect the water.
− Unscrew the cap (1)
− Remove the rubber plug (2) and let
the water out.
− Push the plug into the drain (2)
− Screw on the cap (1)
44