Starting And Stopping The Machine; Preliminary Operations - Nilfisk SR 1101 P Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

STARTING AND STOPPING THE MACHINE

Preliminary Operations

1.
Sit on the driver's seat (25) and adjust it with the lever (31) to allow easy reach of all controls.
NOTE
The driver's seat (25) is equipped with a safety sensor, which allows the machine to be driven only when the operator is
on the driver's seat.
2.
If necessary, adjust the steering wheel (1) to a comfortable position by using the lever (3).
Starting the machine
CAUTION!
Always keep the choke lever in open position before starting the engine: the ignition system does not require
employment of the choke lever.
CAUTION!
Do not start the engine by using the manual starting cord: the engine is equipped with electrical ignition by
starter.
3.
Turn the ignition key (82) to "I", then to "II" and start the engine. When the engine starts, release the ignition key immediately; it
will go back to "I".
CAUTION!
When starting the engine with the ignition key (82) do not press the drive pedal (2).
CAUTION!
After cranking, the engine does not stay at idle, it immediately reaches the target engine speed.
The throttle lever is adjusted by the Manufacturer: do not tamper with it nor use it to change the engine speed!
CAUTION!
The engine cannot be started when the operator is not on the driver's seat (25). A safety system prevents it from
starting.
4.
Warm up the engine for a few minutes, according to the ambient temperature.
5.
Disengage the parking brake.
6.
Drive the machine to the working area, by keeping the hands on the steering wheel and pressing the pedal (2) on the front side
to move forward and on the rear side to move backward.
The drive speed can be adjusted from zero to maximum speed by increasing the pressure on the pedal (2).
6.
Lower and turn on the main broom with the lever (92).
7.
Turn on the vacuum system by pushing the switch (85) backward.
NOTE
The vacuum system turns on only when the main broom is lowered.
8.
Lower the side brooms (10 and 11) with the lever (91).
NOTE
The side brooms (10 and 11) can be lowered and lifted even when the machine is moving.
The side brooms do not turn when they are lifted or when the main broom is lifted.
9.
Start sweeping by turning the steering wheel (1) and moving the machine forward by pressing the pedal (2).
Stopping the machine
10. To stop the machine, release the pedal (2).
To stop the machine quickly, also press the service brake pedal (3).
CAUTION!
In the event of an emergency, to stop all machine functions immediately, firmly press the emergency push-
button (88).
To deactivate the emergency push-button (88), turn it in the direction shown by the arrow.
11. Lift the side brooms (10 and 11) with the lever (91).
12. Turn off the vacuum system by bringing back the switch (85) to the centre.
13. Lift the main broom (12) with the lever (92).
14. To stop the machine, turn the ignition key (82) to "0".
15. Engage the parking brake.
14
INSTRUCTIONS FOR USE
SR 1101 P - 1464020000
revised 03/2018
04/2009

Publicité

Table des Matières
loading

Table des Matières