Dust Filter Cleaning And Integrity Check - Nilfisk SR 1101 P Instructions D'utilisation

DUST FILTER CLEANING AND INTEGRITY CHECK

NOTE
Besides the standard paper filter, polyester filters are
also available. The following procedure is applicable
to each type.
1. Drive the machine on a level ground and engage the
parking brake.
2. Turn the ignition key (82) to "0".
3. Disengage the hook (18) by pulling its lower end.
4. Remove the hopper (17) by using the handle (19) and by
disengaging it from the inner guides.
5. Unscrew the knobs (33) and remove the filter compartment
cover (32).
6. Loosen the knobs (A, Fig. 9).
7. Disconnect the filter shaker motor (C) connector (B).
8. Remove the dust filter fastening frame (D).
9. Remove the dust filter (E).
10. In an outdoor area, clean the filter by shaking it on a level
and clean surface, tapping the side (A, Fig. 10) opposite to
the wire gauze (B).
Complete the cleaning procedure by using compressed air
(C) at maximum 6 Bars, blowing only from the side of the
wire gauze (B), at a minimum distance of 30 cm.
According to the filter type, observe the following cautions:
• Paper filter (standard): do not use water or detergents
to clean it; the filter can be damaged.
• Polyester filter (optional): if necessary, for a better
cleaning, it is allowed to wash the filter with water and
non-lathering detergents. This provides better quality
cleaning but reduces the life of the filter, which will have
to be replaced more frequently. The use of inadequate
detergents can damage the filter.
11. Check the filter body for tears. If necessary, replace the
filter.
12. Clean the rubber gasket (A, Fig. 11) of the cover (32) and
check it for integrity and efficiency; if necessary replace it.
13. Assemble the components in the reverse order of
disassembly, and note the following:
• Install the filter (E, Fig. 9) with the wire gauze (B, Fig.
10) facing upwards.
04/2009
INSTRUCTIONS FOR USE
C
B
A
Figure 9
Figure 10
A
Figure 11
1464020000 - SR 1101 P
ENGLISH
E
A
D
S311397
S311399
S311398
21