Nilfisk SR 1101 P Instructions D'utilisation page 56

ENGLISH
WARNING!
– Do not use the machine as a means of transport, or for pushing/towing.
– When the machine is to be pushed for service reasons (lack of batteries, engine break-down, etc.), the
speed must not exceed 4 km/h.
– Do not allow the brooms to operate while the machine is stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher, not a water one.
– Adjust the operation speed to suit the floor conditions.
– Avoid sudden stops when the machine is going downhill. Avoid sharp turns. Drive at slow speed when
going downhill.
– This machine cannot be used on roads or public streets.
– Do not tamper with the machine safety guards.
– Follow the routine maintenance procedures scrupulously.
– Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
flow.
–
Do not remove or modify the plates affixed to the machine.
–
In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary,
request assistance from the authorised personnel or from an authorised Service Center.
–
If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
–
To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of
this Manual, must be performed by the authorised personnel or by an authorised Service Center.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
oils, plastics, etc.), which are subject to standards that require disposal in special centres (see the
Scrapping chapter).
– While the engine is running, the silencer warms up; do not touch the silencer when it is hot to avoid burns
or fires.
– Running the engine with an insufficient quantity of oil can seriously damage the engine. Check the oil level
with the engine off and the machine on a level surface.
– Never run the engine if the air filter is not installed, because the engine could be damaged.
– Technical service procedures on the engine must be performed by an authorised Dealer.
Only use original spare parts or parts of matching quality for the engine. Using spare parts of lower quality
can seriously damage the engine.
– See also the SAFETY RULES in the Engine Manual, which is to be considered an integral part of this
Manual.
6
INSTRUCTIONS FOR USE
SR 1101 P - 1464020000
revised 03/2018
04/2009