Features - Abus AZ4290 Instructions D'installation

6. Features

The Terxon 2WAY wireless module is a bidirectional wireless enhancement module for wired alarm
systems. It enables you to combine wired alarm centres from any manufacturer with bidirectional Secvest
2WAY wireless components (transducer and activation equipment of the Secvest 2WAY wireless alarm
system). Since the Terxon 2WAY wireless module has relay outputs and voltage-controlled inputs, it can
be integrated not just into the Terxon series but into almost any wired alarm system.
The following Secvest 2WAY components can be integrated using the Terxon 2WAY wireless module:
Secvest 2WAY wireless outdoor sounder FU8220
Secvest wireless indoor sounder FU8230
Wireless remote control 2WAY FU8100
Wireless control unit 2WAY FU8110
Secvest key FU59xx
The Terxon 2WAY wireless module offers up to 8 channels for Secvest 2WAY components. The following
table provides an overview of the respective possible maximum number of 2WAY components that you can
integrate into your wired alarm system with this module.
Article no.
FU8220
FU8230
FU8100
FU8110
FU59xx
The module has:
• 6 switch outputs for controlling the alarm centre. These outputs are wired to zones or inputs of the
alarm centre. These outputs forward the commands from the components received via wireless to
the alarm centre.
• 10 inputs for controlling the Secvest 2WAY system components. These inputs are connected to the
outputs of the alarm centre. The status and control information output by the alarm centre outputs
are forwarded to these inputs and then transmitted via wireless to the 2WAY system components.
• 10 LEDs for visual signalling during programming and operation.
• 3 programming keys
The information that is transmitted between the Secvest 2WAY system components and the alarm centre
via the Terxon 2WAY wireless module depends on the functional scope of the alarm centre. If the outputs of
your alarm centre cannot be programmed to provide the output of specific status information, it will naturally
not be possible to transmit this information to the 2WAY system components. It is therefore important to
check every alarm centre to see whether it is suitable for communicating with the required 2WAY system
components prior to installation.
The Terxon 2WAY wireless module monitors the trained components (supervision). The Terxon 2WAY
wireless module AZ4290 can also detect jamming independently.
The Terxon 2WAY wireless module is protected against code tampering. If you enter a wrong PIN four
times within 60 seconds, or if you use four impermissible proximity chip keys, the Terxon 2WAY wireless
module locks itself for 90 seconds. Exception: If the "BELL" or "FIRE" input is triggered at the same time,
this lock has no effect.
Type
Secvest 2WAY wireless outdoor
sounder
Secvest wireless indoor sounder
Wireless remote control 2WAY
Wireless control unit 2WAY
Secvest key 2WAY wireless
cylinder
31
Maximum number
2
∞
8
8
(8 PIN/proximity chip key for
wireless control units)
8