Programming - Abus AZ4290 Instructions D'installation

10. Programming

Activation
Connect the power supply (12 V). The two connector clamps on the far left are marked
with 12 V for plus and 0 V for minus. The Terxon 2WAY wireless module beeps twice
and the top LED (green) lights up.
Programming
Press SELECT once to go to programming mode.
You are then in the main menu. The lowest LED lights up for menu 1.
Pressing SELECT again lets you choose the following 5 menu items. The corresponding
LED lights up.
Press SET once to get to the menu and the LED switches off or flashes according to the
individual menus. (The exception is menu 8, where all LEDs flash.)
Always close programming mode as described below to ensure that the new settings are
saved.
Please do not simply disconnect the power supply.
Press ESC/DEL until the Terxon 2WAY wireless module starts beeping (about once per
second). Close the Terxon 2WAY wireless module housing and hold the lid tamper contact
SW4 down for about 4 seconds until it beeps twice.
If the Terxon 2WAY wireless module has not been mounted to the wall yet, please keep in
mind that the wall tamper switch must also be pressed or deactivated by the "FIT DISABLE
TAMP" jumper.
All programmed settings and the data of the trained components are saved in an EEPROM. This data is not
lost in case of a power failure.
Menu 1 – Training the components
Press SELECT (top right) once to go to programming mode. The bottom LED (blue) lights up. You are then
in the main menu.
Press SET once to go to menu 1. The bottom LED switches off. Trigger the sending of a wireless signal
from the components to be trained. To train a Secvest 2WAY wireless outdoor sounder, a wireless
operating unit 2WAY or a Secvest Key 2WAY, activate the respective tamper contact(s). To train a
WIRELESS REMOTE CONTROL 2WAY, press any button. Once the first component is trained, the Terxon
2WAY wireless module beeps twice and the LED of the first channel flashes. Repeat this operation for
additional components. This assigns additional channels. Note that a maximum of 8 channels can be
assigned.
Once you're done, press ESC/DEL once. At this point, the Terxon 2WAY wireless module does not let you
press any other buttons. The bottom LED lights up again permanently. You are in the main menu again.
If you want to close programming mode, press ESC/DEL until the Terxon 2WAY wireless module starts
beeping (about once per second). Close the Terxon 2WAY wireless module housing and hold the lid tamper
contact (SW4 underneath ESC/DEL) down for about 4 seconds until it beeps twice. The data is saved in an
EEPROM.
43