Before Installation - LIVARNO LUX HG04245A Instructions De Montage, D'utilisation Et Consignes De Sécurité

CAUTION! DANGER OF
BURN INJURIES! To prevent
burns, verify the product is
switched off and has cooled
down for at least 15 min before
touching it. The product can
become very hot.
FIRE HAZARD!
Fit the product so
0.5 m
that it is at least
0.5 m away from the material
to be illuminated. Excessive
heat can result in a fire.
CAUTION! RISK
OF INJURY! Bro-
ken lamp glass must
be replaced before any further
use is made of the product.
Only intended for installations
out of normal reach.
This product does not contain
any parts that can be serviced
by the user. The LEDs cannot
be replaced.
If the LEDs fail at the end of their
lives, the entire product must
be replaced.
The product continues to draw
a small amount of power even
if the lamp is off as long as
product is connected to supply
mains. To switch the product
off completely, the mains switch
should be switched off.

Before installation

Important: The electrical connec-
tion must be established by a quali-
fied electrician or a person trained
to perform electrical installations.
This person must be familiar with
the properties of the product and
the connection regulations.
Before installation ensure that
the circuit, to which the product
will be connected, is not ener-
gised. To do so, remove the fuse
or switch off the circuit breaker
in the fuse box (0 position).
Use the voltage tester to verify
the de-energised status.
The included mounting material
is suitable for ordinary solid
concrete or masonry construc-
tion. Check which mounting
material is suitable for your
chosen mounting surface. If
necessary, seek expert advice.
GB/IE/NI 9