Installation - LIVARNO LUX HG00375A Instructions De Montage, D'utilisation Et Consignes De Sécurité

Installation

When selecting the mounting location, pay
attention to the following:
1. The solar cell requires direct sunlight when
6
possible. Ideally, the solar cell surface will be
directed to the south. The horizontal direction
of the solar cell is dependent on mounting
on a vertical wall.
2. Depending on the mounting height (ideally
at 2 m) the sensor
of max. 5m with a detection angle of 100°
horizontally and 90° vertically.
3. Be sure the sensor is not illuminated by street
lighting at night. This can influence the effect.
For model HG00375A: Fix the mounting
plate using the provided rawlplugs
2
(ø 6 mm) and the provided screws
(Fig. A).
For model HG00375B / HG00375C:
Fix the mounting plate
rawlplugs (ø 6 mm) and the provided
1
screws . Ensure that the arrow on the
3
has a detection range
7
1
3
using the provided
2
marking of the mounting plate ( UP) is show-
ing vertically upward (Fig. A).
Note: The enclosed mounting material is
suitable for ordinary masonry construction.
Other wall substrates may require other fas-
tening materials. Seek specialist advice when
in doubt.
Set the ON / OFF switch
„ON" to start the operation of the light (For
HG00375A, the ON/OFF switch is inside
the lamp shade at the base. Open the
13
lamp shade to set the switch.) (Fig. G).
Note: In the „OFF" position both the light
and the charging function are disabled.
For model HG00375A: Fix the light
onto the mounting plate using the provided
screws (Fig. B).
12
For model HG00375B / HG00375C:
Attach the device to the mounting plate in
such a way that the hangers
mounting plate grip in the receivers
the back of the device. Slide the device
downwards until the hangers click into
place in the receivers (Fig. B).
to the position
11
of the
4
on
5
GB/IE 9