Types Of Alarm; Disposal; Error Condition And Reset - DAB EVOPLUS B 120/220.32 M Instructions Pour L'installation Et La Maintenance

Set-point reduction percentage
Type of external analogue signal
Twin operating mode
Pump start control
Table 7: Factory settings
Alarm Code Alarm Symbol
e0 - e16; e21
e17 - e19
e20
e22 - e31
e32 - e35
e37
e38
e39 - e40
e43; e44; e45; e54
e46
e42
e56
e57
e58
Tabella 8: Elenco allarmi
50 %
0-10V
= Alternate every 24h
EXT (from remote signal on input IN1).
Alarm Description
Internal Error
Short Circuit
Voltage Error
Internal Error
Electronic system excess temperature
Low voltage
High voltage
Pump blocked
Pressure Sensor
Pump Disconnected
Dry operation
Motor excess temperature (motor
protector trips)
Frequency of PWM external signal less
than 100 Hz
Frequency of PWM external signal
greater than 5 kHz

15. DISPOSAL

This product or any part of it must be disposed of correctly:
- Use public or private local systems for waste collection.
- If that is not possible, contact Dab Pumps or the nearest authorised
service workshop.
INFORMATION
Frequently asked questions (faq) on the ecodesign directive 2009/125/
ec establishing a framework for the setting of ecodesign requirements
for energy-related products and its implementing regulations: http://
ec.europa.eu/enterprise/policies/sustainable-business/documents/
Guidelines accompanying commission regulations implementing the
ecodesign directive:

16. ERROR CONDITION AND RESET

Display
indica- Description
tion
Internal
e0 – e16
error
Low mains
e37 voltage
(LP)
High mains
e38 voltage
(HP)
ENGLISH
Reset
- Switch off system power.
- Wait for the warning lights on the control panel
to go off, then power the system again.
- If the error persists, change the circulator.
- Switch off system power.
- Wait for the warning lights on the control panel
to go off, then power the system again.
- Check that the mains voltage is correct, if ne-
cessary reset it at the plate values
- Switch off system power.
- Wait for the warning lights on the control panel
to go off, then power the system again.
- Check that the mains voltage is correct, if ne-
cessary reset it at the plate values.
GB
35