Installation; General Information; Installing The Stereo Microscope; Fig. 6 Installing The Stereo Microscope - Zeiss Stemi 508 Mode D'emploi

Stereo microscope
Stemi 508
3

INSTALLATION

3.1

General information

Before installing and commissioning the device, make sure to read the Notes on instrument
carefully (see Section 1.2, page 4).
The Stemi 508 with the necessary tools and optional equipment is delivered in several standard packages.
•
Take all units out of the packaging and check them for completeness according to the delivery note.
For installation and/or transport of the microscope or the stand, exclusively use the handle
(Fig. 3/5) provided to this effect.
•
Remove transport securing devices (adhesive tapes etc.).
•
Keep original packaging for a possibly extended period of storage or return of the device to the
manufacturer or dispose of it appropriately.
3.2

Installing the stereo microscope

•
Place stand (Fig. 6/3) on a level, firm support.
•
If the Stemi 508 body (Fig. 6/2) has not yet
been mounted, insert it in the Stemi mount
(Fig. 6/4), align it and secure it using the
clamping screw (Fig. 6/5).
The appropriate Allen key (Fig. 6/8) is located in
the support on the back of the device.
•
If the two eyepieces (Fig. 6/1) have not yet been
mounted, insert them both to their stop in the
eyepiece tube.
•
Insert glass plate or B/W plastic plate (Fig. 6/6)
in the mount in the base of the stand. To this
effect, press the glass plate or the B/W plastic
plate against the spring (Fig. 6/7) and make it
lock in.
Installation
illuminator has been described in
Section 3.3.1 on page 21.
09/2017
INSTALLATION
General information
of a reflected-light
435064-7144-008
Fig. 6 Installing the stereo microscope
ZEISS
19