R E Se T P Ro C Ed U Re; St An D- B Y P Ro C Ed U Re - CTX PRO PH-RX Notice D'installation, Emploi Et Entretien

R E SE T p ro c ed u re

The pump is equipped with a RESET procedure. It can be used any time the user has to reset calibration paramet
Turn off and turn on the pump
Press once the OK button , it will appear SETPOINT
menu
Press at the same time button + and button - (user
has 15 second to make this operation after pressed
OK button )
On the display will appear RESET
ATTENTION: RESET procedure must be performed within 15 seconds from the pump startup. Over this time to use
this procedure, user has to turn off and turn on the pump.

ST AN D- B Y p ro c ed u re

When the pump is in functioning, press at the same time - e +, pump stop, in order to exit to this mode press - and + butto
ENGLISH
85