Steam cooking
∙ Fill the mixing bowl with a minimum of 0.5 litres of water, which is suffi cient for 40 minutes of steaming.
∙ Put the steaming assembly together as described in the section 'Steaming assembly'.
∙ Put in the food to be steamed and fi t the lid.
∙ Use the timer to select the required steaming time and turn the selector switch anti-clockwise to the 120 ° setting.
Tip: While the steaming grid is best suited for gently cooking fi sh or meat, you can steam vegetables at the same time in the
steam tray. However, to cook the food in the grid insert properly, a suffi cient amount of steam is required. Therefore ensure, that
not all the openings in the steam try are blocked by food. Additional side-dishes (such as potatoes or noodles) may be steamed at
the same time in the mixing bowl, with water added up to the max marking.
Acoustic signals, eg programme end etc.
∙ To mark the end of a cooking or mixing cycle, or an improperly locked appliance or other errors, the unit will give acoustic signals.
∙ Once a cooking or mixing cycle has fi nished, always turn the selector switch to the 'Off' position ( ) fi rst before selecting a new
programme or operating time.
Power interruption
In the case of a power interruption while a programme is running, the display shows the error code EE03 and acoustic warning
signals are heard. Should this occur, fi rst switch the appliance off and turn the selector switch to the 'Off' position ( ). Then switch
on again and re-start the cooking or mixing programme.
Error codes - overview
EE01
The mixing bowl is incorrectly fi tted and the appliance is not yet securely locked.
→ Install the mixing bowl correctly and lock the appliance.
EE02
The mixing bowl lid is not fi tted properly and not locked.
→ Fit the lid correctly and lock the appliance.
EE03
The selector switch was not in its 'Off' position ( ) when the appliance was switched on. See also 'Power
interruption'.
→ Switch the appliance off, turn the selector switch to its 'Off' position ( ), and switch on again.
EE04
The temperature inside the mixing bowl is too high.
→ Switch the appliance off, turn the selector switch to its 'Off' position ( ) and allow the bowl to cool down. Put
ingredients or water into the bowl before switching on again.
EE05
The motor jams.
→ Switch the appliance off immediately and disconnect it from the mains. Check whether the blade inside the bowl is
blocked by ingredients. If so, remove the blockage, re-connect the appliance to the mains and switch on again. If the
error message persists, switch off immediately and contact our Customer Service.
EE06
Electronic fault
→ Contact our Customer Service. The contact details can be found in the appendix to this instruction manual.
EE07
Electronic fault
→ Contact our Customer Service. The contact details can be found in the appendix to this instruction manual.
EE08
The locking knob (1) is not in the correct position.
→ Turn the selector switch to its 'Off' position ( ). Check the mixing bowl and lid for correct positioning and lock the
appliance again.
Wind-up cable storage
The wind-up power cord storage on the rear the base helps limiting the length of the power cord during use, and also makes it easy
to store the appliance.
28