Hella KLED-FO Instructions De Montage page 10

Possible
flash sequences
We recommend
programming the lamp
BEFORE mounting
it to the roof.
The programming mode allows the
user to select one of the nine available
flash sequences. Only the ash
sequences 1 and 2 are approved
for use in Europe.
10
Setting
the flash sequences
1. The lamp must be activated (white
to plus + , brown to minus – ).
2. The "synchronisation" input (green)
is connected to plus +.
3. After approx. 2 seconds the flash
sequence selection mode is activated;
the lamp now starts to flash with
approx. 1 Hz. After every flash cycle,
the next flash sequence is activated,
although it always starts with the first
1
2
3
4
5
6
7
8
9
250 ms
2XD 010 311-201
2XD 010 311-001
2XD 010 311-101
flash sequence. If you want to select
the 4th flash sequence, the input
"Select flash sequence" (green) needs
to be disconnected from plus + after
the 4th flash.
500 ms 750 ms
Flash sequence options:
1. Simple flashing
2. Double flashing
3. Triple flashing
4. Quadruple flashing
5. Simple flashing
(250ms o set to flash sequence 1 )
6. Double flashing
(250ms o set to flash sequence 2)
7. Triple flashing
(250ms o set to flash sequence 2)
8. Quadruple flashing
(250ms o set to flash sequence 2)
9.Simple flashing, 1 Hz
2XD 010 311-201
2XD 010 311-001
2XD 010 311-101
ECE
1 s