Hella KLED-FO Instructions De Montage page 27

Approval
Hella rotating signal lamps (K-LED
Art.-No. 2XD 010 311-001, ...-011,
...-021) have been o cially type-
tested within the scope of ECE-R65.
Electrical connection
(Plus line with fuse)
Use a cable diameter of
2
min. 1.5 mm , 10 A slow-blow fuse
Assembly
27
> 0,6 mm
Technical data
Operating voltage range:
Mean power draw
yellow/red:
Mean power draw
blue/green:
They need to be mounted at the
highest point of the vehicle and, when
the vehicle is loaded during operation,
they must be vertical to the road
surface. All rotating signal lamps are
RFI suppressed and comply with VDE
A
Select the right position on the roof
of the vehicle (see specifications). If the
defined visibility (see Road Tra c
Licensing Regulations- StVZO) cannot
be satisfied due to structures on the
roof of the vehicle, further
r > 3000 mm
signal lamps must be mounted.
M4 screws need to be used to attach
them from below.
10–32V Flash sequence:
12V: 1,5A | 24V: 0,8A Temperature range:
Plus line with fuse:
12V: 2A | 24V:1A Reverse voltage protection: Yes
Light hood:
0879 Part 2. They are EC-approved
according to RL72/245 EWG in the
version 2006/28 EC
Simple, double, Casing:
triple, quadruple flash Protection class:
-40°C to +60°C RFI suppression:
10A slow-blow e1 Approval according to 72/245 EWG in
the version 2006/28 EC.
PC
AL DG
IP 5K, 4K, 9K