Hendi 297360 Mode D'emploi page 7

7. Essential characteristics of tools which can be assembled on the machine
The tenderiser appliance is supplied with a knife
shaft drive (AM) and knife driven shaft (AC) with
specifi c dimensions selected by HENDI POLSKA
SP. Z O.O.HENDI POLSKA SP. Z O.O.
HENDI POLSKA SP. Z O.O.HENDI POLSKA SP. Z O.O.
8. Maintenance
Those components subject to wear are essentially
those which cut; in this case, the two shafts (AM -
AC). Continually check shaft conditions, replacing
when necessary.
For spare parts, we recommend using HENDI
POLSKA SP. Z O.O.HENDI POLSKA SP. Z O.O. SRL -
original parts to prevent inconveniences due to dif-
9. Accidental shutdowns
In the event of unexpected shut-down of the machine
during processing, before searching for the cause,
promptly stop motor power by pressing the button
(O) and then, next, unplug the power cord.
Once you have done so:
• If the shut-down is due to a mains power outage,
do not plug the machine back in until normal
10. Discarding & Environment
When decommissioning the appliance,
the product must not be disposed of
with other household waste. Instead, it
is your responsibility to dispose to your
waste equipment by handing it over to a designated
collection point. Failure to follow this rule may be
penalized in accordance with applicable regula-
tions on waste disposal. The separate collection
and recycling of your waste equipment at the time
- is not responsible for any injuries resulting from
use of the MEAT TENERISER appliance with shafts
or knives available on the market with differing di-
mensions.
fering production characteristics. When ordering,
specify the model, serial number of the machine in
possession (the serial number is indicated on the
ID plate located on the power unit (MT) as well as
on the declaration of conformity) and the reference
number of the part.
mains conditions have returned.
• If shut-down has been caused due to overload-
ing, press the stop button (O), unplug the ma-
chine from the mains, then mechanically discon-
nect the entire cutting unit from the application
fl ange (FL). At this point, you can dismantle the
cutting unit, removing any cause of the blockage.
of disposal will help conserve natural resources
and ensure that it is recycled in a manner that pro-
tects human health and the environment. For more
information about where you can drop off your wa-
ste for recycling, please contact your local waste
collection company. The manufacturers and impor-
ters do not take responsibility for recycling, treat-
ment and ecological disposal, either directly or
through a public system.
EN
7