Yamaha Banshee 350 Manuel Du Propriétaire page 310

1
a
1. Punch mark
1. Poinçonné
1. Marca de punzón
q
1. Locknut (×2)
×
1. Contre-écrou ( 2)
1. Tuerca de bloqueo (×2)
a. Specified position : 0–1mm
a. Position spésifiée : 0 à 1mm
a. Posición especificada : 0–1mm
w
2. Adjusting nut (×2)
×
2. Écrou de réglage ( 2)
2. Tuerca de tensor (×2)
7. Tighten the carburetor cap securing plate
screw to the specified torque.
Tightening torque:
3.5 Nm (0.35 m0kgf)
8. Tighten the carburetor joint screws.
Adjusting the throttle cables
NOTE:
After the jet needle clip position is changed, the
throttle cables may need to be adjusted.
1. Move the throttle lever a few times.
2. Push the throttle lever forward until it stops
and hold it in this position.
3. Check through each carburetor window to
see if the punch mark on the throttle valve
is at the specified position.
4. If not, loosen the locknut and turn the
adjusting nut until the specified position is
obtained.
5. Move the throttle lever a few times and
recheck the position.
6. Install the fuel tank, side cover, radiator
cover and air filter case cover.
7. Connect the fuel hoses.
8. Install the seat.
8-65