Tractel pal-turn Notice D'utilisation page 17

GB
Different types of straps
Endless straps can be used without special precautions on their length
The straps with connecting buckle (recommended in case of difficulties reaching the extremities of
the load), have to be the object of a very intensive attention during their use. The steel joints are
not allowed to pass inside the pulleys and the non-coated connecting buckle never has to lean to
the sharp edges during the turning.
In case of 360° turning the load, the length of the straps must allow the turning of the load following
the wanted angle without that the steel joints pass inside the pulleys.
Furthermore, the steel joints of each strap have to be positioned at the same level to facilitate the
control of their position during the rotation of the load.
Straps fasteners.
There are 2 models of fasteners for opening straps:
C hook with safety catch. Mechanical opening system
Straps with width : 30 to 90 mm Staps with width : over 90mm
M 6119 M
rev 8 – 10/2021
Page 17/48
www.tractel.com