1
General information
Technical documentation contains important infor-
mation for safe operation and for retaining func-
tional safety of the lift.
• To verify lift set up, the assembly protocol form is
to be completed, signed and sent to the manu-
facturer.
• Forms are available in this inspection book for use
in verifying single, regular and extraordinary safety
checks. Use the forms to document inspections and
leave the completed forms in the inspection book.
• The lift master forms must record changes to the
construction or changes to set up location.
1.1
Set up and test the lift
Safety relevant work on the lift and safety inspec-
tions may only be done by personnel specifically
trained to carry it out. They are designated in gen-
eral and in this documentation as technical experts
and specialists (competent people).
• Technical experts are people (freelance expert
engineers, TÜV specialists) that may inspect and
assess due to their education and experience
with lifts. They are knowledgeable in the appro-
priate work safety and accident prevention reg-
ulations.
• Specialists (competent people) are people who
have sufficient knowledge and experience with lifts
and have participated in a special factory training
by the lifts manufacturer.
1.2
Hazard information
To become aware of the hazardous points and im-
portant information, the following three symbols are
used with the descriptive meaning. Pay particular
attention to text positions that are labelled by these
symbols.
Note! Labels information about a key function or
i
points to an important remark!
Caution! identifies a warning of possible system
!
damage or other operating company property
damage if the highlighted process is not done
properly!
Danger! Identifies a danger to life and
limb, if the highlighted process is not
done properly there is a mortal dan-
ger!
78
OPI-POWER LIFT HF 4600-V3.0-DE-EN-FR-ES-IT