Lift Synchronization; Lowering The Vehicle - Nussbaum POWER LIFT HF 4600 Manuel D'exploitation

• Check that there are no people or objects in the
hazardous area of the lift.
• Afterwards, lift the vehicle to the desired working
height.
Ensure secure vehicle placement on
the carrier plate, otherwise there is a
danger of the vehicle dropping.
i See to it that the lifting arm blocks are ratcheted
in after the vehicle has been accepted.
Operation with push button (standard)
Operation with lever (option)
Lift: Lift lever and push
Lower: Lift lever and pull
90
5.3
• Uneven running of the lift is not possible in proper
• For this, raise the lift to its uppermost end position.
• Release the operating lever. The lift rails then
• Both lift rails are now at the same height.
5.4
• Check that there are no people or objects in the
• Lower the vehicle to the desired working height
Operation with push buttons
• Then lower onto the locks by pushing button
Main switch
• Before starting the lowering process, the lift must
Lift
Lower into latches
Lower
Operation with lever
• Then lower onto the locks by push-
• Before starting the lowering pro-
Lower into latches
• Lower the lift to the floor
Main switch
• For heavier vehicles, lift it slightly before lowering
• Once the lift is in the lowest position, push the lift-
Operating lever

Lift synchronization

operation.
Press the "Lift" button (the operating lever) for 2
more seconds. During this procedure the lift rails
are equalised to each other as hydraulic oil flows
to the tank as an overflow from the command
cylinder via the downstream cylinder to the tank.
lower some millimetres and thereby block the
overflow opening of the cylinder.

Lowering the vehicle

hazardous area of the lift.
or to its lowest position; press the "Lower" button
(pull the operating lever slowly) v "Lower".
"Lower into latches".
- The lift moves down a little and sets down in the
next latch
be moved out of the latch again.
- Press the "Lift" button briefly to unlock the latch
- Press button "Lower" for lowering the lift to the
floor
ing button "lower into latches"
and at the same time lift and pull
the operating lever.
- The platform moves down a little and sets down
in the next latch
cess, the lift must be moved out of
the latch again.
- Lift and press the operating lever
briefly to unlock the latch
to prevent an "sticking" and any corresponding
jolt during lowering.
ing arms to the start position.
OPI-POWER LIFT HF 4600-V3.0-DE-EN-FR-ES-IT