Before Placing Food In The Appliance - Signature SRB3000 Manuel D'utilisation

3. Pulled out the bottom panel before
installation.
4. The appliance can be adjusted by rolling its
two legs in front the bottom when it is unstable.
Rolling in clockwise can rise up the machine.
5. The location should be firm and flat. An
un-securely position may cause noise and
libration:
(a) The noise may be increased if the floor is
not firm.
(b) Put a sheet under the appliance for
solving the heat emission if you need to
locate it onto a carpet.
6. Make sure the adjustable legs are clung to the floor, and set the appliance slope
backward slightly for keeping the doors closed tightly.
Additional spacers for better performance
There are 2 additional spacers in the bag. We suggest you install these 2 spacers to There are 2 additional spacers in the bag. We suggest you install these 2 spacers to
your appliance as per the diagram below.

BEFORE PLACING FOOD IN THE APPLIANCE

• Remove all packaging.
• Allow the appliance to run empty for 2 – 3 hours so the
compartments can cool to the appropriate temperature.
• Clean the inside of the appliance with warm water and
oor, and set the appliance slope
43