Danger Of Explosion; Unpacking & Inspection - Antari Z-SERIES Mode D'emploi

Always allow your ANTARI Fog Machine to cool down before attempting to clean or service it.
♦

Danger of Explosion

Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.
♦
Use only high-quality, water-based fog liquid that your dealer recommends. Other fog liquids may cause
♦
clogging or "spitting".
♦ Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage to
the pump as well as over-heating of the heater.
If your ANTARI Z-1500II or Z-3000II Fog Machine fails to work properly, discontinue use immediately. Drain all
♦
fog liquid from the tank, pack the unit securely (preferably in the original packing material), and return it to your
ANTARI dealer for service.
Always drain tank before mailing or transporting this unit.
♦
Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin or eyes,
♦
rinse thoroughly with water.
Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. The
shipping carton should contain the following items:
1. One unit of One unit of Z-Series II Fog Machine
2. Power cord
3. Z-20 multi-function remote control with attached cord
4. User Manual
If any equipment is missing contact your ANTARI dealer immediately.
Before beginning your initial setup on ANTARI Z-1500II or Z-3000II Fog Machine, make sure that there is no
evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in
and do not attempt to use it until after contacting your ANTARI dealer for assistance.
Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
♦
especially in the nozzle area.
Place fog machine on a flat surface and remove fog liquid tank cap.
♦
Fill with ANTARI fog liquid or other high-quality water-based fog fluid recommended by ANTARI dealer. Any
♦
other types of fluid can damage the unit resulting in spitting and serious clogging problem. When filled, place
cap back on liquid tank. Be careful not to exceed the maximum fluid level. DO NOT OVERFILL.
♦ Firmly attach the Z-20 control module cable to the connector inside the rear chamber of the machine.
Operation
Add fluid carefully to the liquid tank. Do not overfill the tank.
♦
The Plug should be in a position that is accessible when using the machine.
♦
Plug power cord into a grounded electrical outlet. Turn the power switch to "ON" on the back of the machine.
♦
Warm-up is completed when the display on the control module shows "Ready to Fog"
To emit fog press the appropriate button on the control module for the desired length of time.
♦
The control unit display will display "Warming up" and "Ready to fog" as the machine re-heats to the proper
♦
operating temerature.
For further information on operating your Z-1500II, Z-3000II Fog Machine, see the section titled "Remote
♦
Control Operation".
CAUTION:
"Visibility during operation is reduced"
This model can be operated at a floor level or sitting on any regular surface. Whatever installation method you
choose, do not allow the unit to have more than 15 degree angle of inclination.
3