Danger Of Fire - Antari S-120 Mode D'emploi

Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system
has arrived intact. Accompanying the S-120 foam machine should be a hanging bracket
and fluid tank. If any equipment is missing contact your ANTARI dealer immediately.
Before beginning your initial setup on the ANTARI Foam Machine, make sure that there is
no evident damage caused by transportation. In the event that the unit's housing or cable
is damaged, do not plug it in and do not attempt to use it until after contacting your
ANTARI dealer for assistance.
Setup
♦ Remove all packing materials from shipping box. Check that all foam and plastic
padding is removed, especially in the nozzle area.
♦ Place the machine on a flat surface and remove the liquid tank cap.
♦ Fill with ANTARI Foam Liquid or other dealer-recommended high-quality water-based
snow or foam fluid. Any other types of fluid can damage the unit. When filled, place
cap back on liquid tank.
Installation
The Foam Machine may be installed at floor level or suspended overhead. Install the
Foam machine in a well-ventilated area. Never cover the unit's vents. In order to
guarantee adequate ventilation, allow a free air space of at least 20 cm around the sides
and top of the unit. Install the device out of the public area. Please consider that liquid may
be spilt during operation around the device. The resulting slippery surface can cause
accidents. Position output of foam away from persons. The minium distance should be
1.5 m. Only install the machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exceed 15°.
When installing the device, make sure there is no highly-inflammable
Material (decoration articles, etc.) within a minimum distance of 0.5 m.
This device is constructed for a standing installation only. If the device is to be installed
overhead, the following safety instructions are binding:
The installation of the device has to be built and constructed in a way that it can hold 10
times the weight for 1 hour without any harming deformation.
Please consider the EN 60598-2-17 and the respective national norms during
the installation! The installation must only be carried out by an authorized
dealer!
The installation must always be secured with a secondary safety attachment, e.g. an
appropriate catch net. This secondary safety attachment must be constructed in a way that
no part of the installation can fall down if the main attachment fails.

DANGER OF FIRE!

DANGER TO LIFE!
3