Antari Z-SERIES Mode D'emploi page 5

Z-20:
1. LCD-Display
2. FUNCTION-Button
3. UP-/DOWN-Button
4. TIMER-Button
5. VOLUME-Button
6. MANUAL-Button
1. Via the FUNCTION Button, you can adjust the desired settings. Pressing the FUNCTION Button will cycle
through different options including Volume, Timer, Heat & Fan. The ENTER (VOLUME) Button is used to select
the desired option. To adjust fog output volume setting, simply go into VOLUME option. Adjust the volume
percentage (within the range of 1% to non-stop burst) by means of UP/DOWN Buttons. To adjust timer setting,
go into TIMER option. Cycle through Interval (within the range of 1 to 900 seconds), Duration (within the range
of 1 to 200 seconds), and Volume (within the range of 1% to non-stop burst) by means of UP/DOWN Buttons.
Use ENTER (Volume) Button to select each option and make changes as desired. To turn OFF the heater and
fan, go into Heat & Fan option. Use ENTER(Volume) Button to confirm the selection. Use ON/OFF (MANUAL)
Button to turn it ON.
2. Always press ENTER (VOLUME) Button to confirm setting.
3. Press ESC (TIMER) Button to exit current menu level and move to an upper (previous) level.
4. Press TIMER Button to activate the timer function. The display shows the adjusted interval and the device
counts the seconds down to "O". After that, the fog emission is triggered at the volume adjusted under " Timer
Option". The duration depends on the settings adjusted under "Duration". If you wish to deactivate the timer
function, press the Timer Button once more.
5. Press the VOLUME Button for immediate triggering of the fog emission at the volume adjusted under
"Volume" Option. Press the VOLUME Button once more in order to stop the fog emission.
6. Press the MANUAL Button for immediate triggering of the fog emission at 100% volume. Let the MANUAL
Button loose in order to stop the fog emission.
7. When in Standby mode, press ON/OFF Button to reactivate the machine.
Z-30: All the Z-20 features plus wireless capability. Wireless operation is possible up to a distance of 50 meters.
♦
The address can be set from 0 to 8, which means a max. 9 different units can be controlled separately or in any
combination desired. Press FUNCTION to cycle to RF mode to select desired address number. Make sure the
address setting on the Z-30 matches the address setting on the transmitter. There are two buttons on the
transmitter. The blue one is to emit fog and red one is to stop the operation.
Performance Note
All fog machines develop condensation around the output nozzle. Because this may result in some moisture
♦
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
♦
being turned off.
All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
♦
period in order to heat up again. During this time no fog can be produced.
Maintenance
Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and the
fog machine liquid tank immediately after filling. After every 40 hours of continuous operation, it is recommended to
5