Sony HT-CT500 Mode D'emploi page 24

Installing the speaker on a wall
You can install the speaker on the wall.
Notes
• Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach
the screws securely to a wall beam. Install the speaker on a vertical and flat reinforced area of the wall.
• Be sure to subcontract the installation to Sony dealers or licensed contractors and pay special attention to safety
during the installation.
• Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength,
improper screw installation or natural calamity, etc.
1
Prepare screws (not supplied) that are suitable for the holes on the back of the speaker.
See the illustrations below.
2
Fasten the screws to the wall. The screws should protrude 6 to 7 mm (approx.
3
Hang the speaker onto the screws.
Align the holes on the back of the speaker to the screws, then hang the speaker onto the two screws.
24
US
more than 25 mm (1 inch)
5 mm
( /
1
10 mm
( 2 /
Hole on the back of the speaker
6 to 7 mm
(approx. / inch)
1
4
4 mm ( 1 / inch)
6
inch)
5
inch)
5
265 mm
(10 2 / inch)
5
1
/ inch).
4