Güde GSE 2501 Traduction Du Mode D'emploi D'origine page 19

Operator Safety Instructions
See General Safety Instructions and Initial Operation Safety Instructions.
•
Do not use the machine until you have read the instruction manual carefully.
•
Observe any safety instructions included In the manual.
• Be responsible to the others
Troubles – Causes – Troubleshooting
Trouble Cause
1.
2.
The engine will not
3.
start up .
4.
5.
6.
1.
Engine runs unevenly
2.
•
•
•
No current from
generator.
Inspections and Maintenance
Regular cleaning and maintenance is essential for perfect functioning and long service life of the unit.
No smoking in the course of the described jobs.
Never work close to sparks, flames or open fire.
Air Filter
The air filter should be cleaned every 50 hrs of operation
•
Loosen 2 hexagon-head screws.
•
Remove the cover.
• Remove the air filter.
• Clean the filter with spirit or ethanol
•
Drop a small amount of oil on the air filter and compress it.
•
Put the filtration cartridge back and put the housing on.
Fuel Filter
•
Remove the lid from the filler.
•
Pull the fuel filer from the filler
•
Clean the filter with spirit or ethanol
• Dry it with a soft cloth.
• Put the filter back in the filler.
Fuel cock closed
No fuel
The starter pull too weak
The ignition plug too distant
Ignition plug socket loose, wet
Ignition plug socket loose
Too little oil in the tank
Too small appliance
Ignition system not in order
Poor fuel
Short circuit
Defective cable
Loose cable
Troubleshooting
1.
Make sure that the fuel cock on/off
switch are in on position
2.
Make sure that there is enough fuel in
the tank.
3.
Pull the starting cable stronger.
4.
Make sure that the ignition plug is
properly mounted.
5.
Make sure that the ignition plug cable is on the
plug. Clean the plug and check the electrode
distance.
6.
Replenish the oil
1.
Make sure that the plug is properly
mounted. Make sure that the plug cable
is on the plug. Clean the plug and check
the electrode distance.
2.
Make sure that the used fuel is correct.
1.
If the light indicator is off, the defect is
impossible to be cleared by yourself. .
If the light indicator is on :
2.
Press the overloading protection for the
required output.
3.
Check the connection
4.
Check whether a short circuit or overloading is not
the cause.
19