Cleaning And Storage; Troubleshooting - MAXXMEE WJ100 Mode D'emploi

Dartboard

CLEANING AND STORAGE

Please Note!
■
Do not use any sharp or abrasive
cleaning agents to clean the product.
These may damage the surfaces.
• Wipe down the product with a damp
cloth if necessary.
• The darts can be stored in the prod-
uct when they are not being used. To
do this, place one dart in each of the
recesses on the sides of the product.
• Store the product and the accessories
in a clean, dry place that is out of the
reach of children and animals.

TROUBLESHOOTING

If the product does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical product yourself!
The product does not work, the
display does not switch on / no beep
is heard.
The batteries are too weak or empty.
► Replace the batteries.
The product does not count any
points / hits.
The game was not started.
► Press the START/NEXT button to start
the game.
A segment or a button are tilted.
► Move all segments back and forth
gently with your fingers, carefully
remove a dart which is stuck and care-
fully release the buttons from any tilt.
L
In the case of a tilt, all previous
scores may be erased in some cir-
cumstances. You can only continue
playing normally once the tilt has
been released.
The display flickers or switches off in
between times.
Electromagnetic interference disrupts the
electronics of the product. This may be
caused for example by a storm, thun-
derstorm, direct proximity to an electric
motor or a microwave etc.
► Remove the batteries from the prod-
uct for a few seconds, reinsert them
and restart the product.
► If possible, remove the interference.
EN
25