Inserting / Replacing Batteries; Wall Mounting; Assembling The Darts - MAXXMEE WJ100 Mode D'emploi

EN
manufacturer in order to guarantee
that there is no interference that may
prevent the product from working and
to avoid possible damage.
INSERTING / REPLACING
BATTERIES
Before inserting the batteries, check
whether the contacts in the product and
on the battery are clean, and clean them if
necessary.
1. Remove the screw on the battery
compartment cover using a suitable
screwdriver.
2. Take off the battery compartment
cover.
3. Insert three 1.5 V batteries, AA into the
battery compartment. Pay attention to
the polarity (+ / –)!
4. Place the battery compartment cover
back on and tighten the screw so that
it is hand-tight.
Replace the batteries if the power starts
to wane.
18

WALL MOUNTING

Please Note!
■
Use suitable fixings to hang up the
product. If you are unsure whether
the fixings supplied are suitable for
the wall, seek advice from a specialist
retailer.
■
Attach the product in a secure place
on a dry surface.
■
Before drilling, ensure that there are
no pipes or cables behind the intend-
ed drilling point.
Hang up the dartboard on the hanging lug
with at least one screw.
For a secure fixing, screw two more screws
into the recesses which are provided for
them and the wall behind.
L
The dartboard should be attached
at a height of approx. 1.73 metres
(from the floor up to the bullseye).

ASSEMBLING THE DARTS

A B
1. Place a tip (A) into each barrel (B).
2. Securely screw a shaft (C) in each
barrel.
3. Unfold the flights (D) and place a flight
into the tip of each shaft. Make sure
that a blade fits into each recess.
C
D