Management; Storage; Transport; Weight And Dimensions - DAB P1-900 Instructions Pour L'installation Et La Maintenance

Electrical data
Hydraulic data
Range of use
Weight
The pump which does not stand on a base cannot support the weight of the pipes, which must be
supported in some other way.

4. MANAGEMENT

4.1 Storage

All the pumps must be stored in a dry covered place, with possible constant air humidity, free from vibrations and dust.
They are supplied in their original pack in which they must remain until the time of installation.

4.2 Transport

Avoid subjecting the products to needless impacts and collisions.

4.3 Weight and dimensions

The adhesive plate on the packaging indicates the total weight of the pump and its dimensions.

5. WARNINGS

The pumps must never be carried, lifted or allowed to operate suspended from the power cable; use
the handle and cord provided.
Before installation, dredge any sand and other solid particles from the cistern.
The motor's power cord must be secured to the delivery pipe with plastic clamps every 2 or 3 m.
Use the check valve provided.

The pump must never be allowed to run when dry.

The sealing device contains lubricant which is non-toxic but which may alter the characteristics of the water, in the
case of pure water, if the pump were to have any leaks.

6. INSTALLATION

Screw first the non-return valve and then the nipple using the connector ideal for ¾'' and 1'' pipes provided in the
packaging. If a pipe with greater diameter is to be used, change the connector. Use a pipe tightening clamp to secure the
pipe to the fitting Fig.1

It is advisable to use pipes having a minimum internal diameter of ¾'' mm, to avoid the decrease of pump
performance.

To avoid obstruction of the suction passages, it is recommended to check periodically that no dirt has accumulated in
the collection cistern (leaves, sand, etc.). It is advisable to leave a minimum distance of 20 cm to avoid clogging of
the suction grid (Fig.2)

Insert the plug in a socket, main power must to be 220-240V.
Model
P1 Rated absorbed power [W]
P2 [W]
Mains voltage [V]
Mains frequency [Hz]
Current [A]
Capacitor [µF]
Capacitor [Vc]
Max. flow rate [l/min]
Max. head [m]
Max. head [bar]
Max. immersion depth [m]
Min. submersion height [cm]
N. of impellers
Length of power cable [m]
Type of cable
Grade of motor protection
Insulation class
Liquid temperature range [°C]
according to EN 60335-2-41 for domestic use
Max. particle dimension [mm]
Max. ambient temperature [°C]
DNM GAS
Net/Gross weight approx. [kg]
ENGLISH
P1=750
550
330
2.7
8
425
24
2.4
2
8/8.8
Table 3
2
P1=900 P1=1100
900 1100
650 750
220-240 AC
50
3.8 4.8
12.5 12.5
450
95
36 46
3.6 4.6
12
12
3 4
15
H07 RNF
IP X8
F
0 °C / +35 °C
Ø 1
+40 °C
1'' F
8.7 / 10 9 / 10.2