Erreka RINO Manuel De L'utilisateur page 63

SW2 functions
Functions during programming
(DIP1=ON)
DIP2=ON: total open/close programming (see
page 61)
DIP3=ON: pedestrian open/close programming (see
page 62)
DIP4=ON: total opening radio code programming (see
page 60)
DIP6=ON: pedestrian opening radio code
programming (see page 60)
PROGRAMMING AND STARTUP
Functions during use (DIP1=OFF)
DIP2: advance warning

DIP2=ON: the flashing light comes on and the
operation begins after a 3 second warning.

DIP2=OFF: the flashing light comes on and the
operation begins immediately.
DIP3: step-by-step or collective opening

DIP3=ON: step-by-step opening (the panel obeys
the key commands during opening).

DIP3=OFF: collective opening (the panel does
not obey the key commands during opening).
DIP4: automatic or step-by-step closing mode (in
total and pedestrian operation)

DIP4=ON: automatic mode (the gate closes
automatically after the standby time has passed,
which is adjusted using T.E.).

DIP4=OFF: step-by-step mode (the gate only
closes when receiving the key command).
DIP5: automatic mode optional (only if DIP4=ON)

DIP5=ON: during standby, the gate obeys the
key commands (this can be closed before standby
time finishes).

DIP5=OFF: the gate cannot be closed until
standby time finishes.
DIP6: opening photocell testing

DIP6=ON: testing enabled

DIP6=OFF: testing disabled
DIP7: encoder activation

DIP7=ON: encoder enabled

DIP7=OFF: encoder disabled
DIP8: slowdown function

DIP8=ON: the gate reduces its speed before
reaching the stopper.

DIP8=OFF: the gate reaches the stopper at high
speed.
DIP9: closing photocell testing

DIP9=ON: testing enabled

DIP9=OFF: testing disabled
DIP10: Type of slowdown (only if DIP8=ON)

DIP10=ON: progressive slowdown (deceleration
ramp 1.5 seconds)
RINO operator for sliding gates
59