Installation - CONSTRUCTA CD30636 Notice D'utilisation

Connect the power cord provided to the appliance. ¨
2.
Use the strain relief to secure the power cord in place.©
3.

Installation

Installation
Use the angle brackets to hang the appliance on the screws
1.
and align it.
Measure the distance from the appliance to the wall and
2.
mark this on the filler strip.
If required, shorten the filler strip to the required dimension.
3.
26
Screw the two angle brackets to the appliance. Ensure that
4.
the screws are positioned correctly.ª Screw in the screws
until 8 mm of the threaded section is still protruding. «
Remove the appliance and screw in the filler strip.
4.
Remount the appliance, align it and screw it in place.
5.
Carefully screw in all screws.
Establish the electrical connection.
6.
Note: The extractor hood's housing can be concealed within
the upper cabinet. In doing so, you must observe the following:
The intermediate floor must not be placed on the extractor
■
hood's housing.
The front panel must not be secured to the housing.
■
Access must be available in order to change the filter and for
■
after-sales service.