Trouble Shooting - CONSTRUCTA CD30636 Notice D'utilisation

Removing metal grease filter
Open the lock and fold down the metal grease filter. While
1.
doing this, place your other hand under the metal grease
filter.
Take the metal grease filter out of the holder.
2.

Trouble shooting

Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Malfunction table
Problem Possible cause Solution
The appliance The plug is not
does not work plugged in.
Power cut
Faulty fuse
The lighting The bulbs are
does not work. faulty.
--------
20
Connect the appliance to
the electricity supply
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the fuse for
the appliance is OK
For information on chang-
ing the bulbs, see the
"Replacing Bulbs" section.
Notes
Fat may accumulate in the bottom of the metal grease filter.
■
Hold the metal grease filter level to prevent grease from
■
dripping out.
Clean the metal grease filter.
3.
On appliances with a glass plate in the filter pull-out:
The glass plate can be removed easily and can be cleaned in
■
the dishwasher.
To remove it, carefully lift the glass plate.
■
Installing the metal mesh grease filter
Insert the metal mesh grease filter.
1.
While doing this, place the other hand under the metal mesh
grease filter.
Fold the metal mesh grease filter upwards, locking it in place.
2.
Replacing bulbs
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
:
Risk of burns!
Halogen bulbs become very hot when switched on. There is still
a risk of burning for some time after they have been switched
off. Allow the halogen bulbs to cool down before replacing
them.
:
Risk of electric shock!
When changing the bulbs, the bulb socket contacts are live.
Before changing the bulb, unplug the appliance from the mains
or switch off the circuit breaker in the fuse box.
Important! Only use bulbs of the same type and wattage.
Replacing halogen bulbs
Note: When inserting halogen bulbs, do not touch the glass
tube. Use a clean cloth to insert the halogen bulbs.