Christopeit Sport CX 6 Notice De Montage Et D'utilisation page 23

Installation instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts have been connected directly to
the main frame and preassembled. In addition, there are several other
individual parts that have been attached to separate units. This will make
it easier and quicker for you to assemble the equipment.
Assembly time: 45 -60 min.
Step 1:
Installation of front and rear foot (2+3) at the main frame (1).
1. Place the bolts (6) and each two washers (7), spring washers (8) and nuts
(9) ready for use beside the front and rear part of the main frame (1).
2. Place the front and rear foot (2+3) into the bracket of the main frame (1)
and align so that the hole patterns of the bracket and the foots are in
conformance.
(Note: The front foot caps with transport roller units (4) installed in the
front foot bar (2) must point forwards (as viewed when training, standing
on the machine).
3. Push one screw (6) each through the bores.
4. Install one washer (7) and one spring washer (8) each on the ends of
the screws (6) and fasten with one nut (9) each. (You can use adjustable
screw (10) to level the bike.)
Step 2:
Connecting the computer cables (17+18) and installation of handlebar
post (19).
1. Place the lower end of the handlebar post (19) against the main frame
(1). Connect the two ends of the computer cable (17) and (18) projecting
from (1) and (19).
2. When the electrical cable connections have been made, push the hand-
lebar post (19) into the main frame (1). (Note. When pushing the tubes
together, ensure that the electrical cable connection is not trapped.
The short tube welded crosswise to the upper end of the tubular sup-
port (19) must point forwards (as viewed when training standing on the
machine).
3. Push one spring washer (14) and one washer (15) or curved washer (16)
on each of the bolts (13). Push the bolts (13) through the bores in the
main frame (1), screw into the threaded holes of the handlebar post (19)
and tighten firmly.
23