Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Program level
1
2
3
Safety Instructions
• Do not open the furnace during the wax burnout phase.
• Investments contain quartz. Do not inhale the dust! Risk of lung damage (silicosis, lung cancer).
Recommendation: Wear a protective face mask, type FFP 2 EN 149:2001.
Prevent the release of dust when opening the bag and fi lling the mixing bowl.
• Rinse the empty bag with water before crumpling it up.
• Always moisten any dust before removing it from the workplace.
• After casting, place the completely cooled mould in water until it is fully moistened to prevent dust
when devesting.
• Use an extractor with a fi ne dust fi lter when sandblasting.
We always attempt to include the latest results for our investment materials (development and appli-
cation) in the instructions. Excellent precision of fi t and surfaces are achieved with Kulzer equipment
and materials. The results may vary if other materials (e.g. casting ring liners, waxes, equipment etc.)
or diff erent techniques are used.
The fi gures given by our research and development department are guidelines and can be individu-
ally adjusted.
8
Temperature
(°C)
approx. 23°C room temp. -
270°C
270°C - 580°C
580°C - final temp. (950°C)
We appreciate your comments, feedback, and suggestions.
Contact in the countries and more information are available by the displayed
QR code or at our website www.kulzer.com
Programmed preheating
Heat-rate
(°C/min.)
X1
8
30
8
30
8
40
Hold-times (min.)
Correct size of mould
X3
X6
X9
40
45
50
30
30
30
40
40
40
Publicité
Table des Matières
