Replacing Filters; Replacing The Non-Return Valve - Franke 5183 21 23 Notice De Montage Et De Mise En Service

16. Replacing Filters

Filter corner valve
16.1 Close the corner valves (c).
16.2 Trigger the valve.
16.3 Unscrew the connecting hoses (a) together with the connector pieces from the corner
valves.
16.4 Replace the filters (b).
16.5 Reassemble in the reverse order.
Filter in solenoid valve cartridge
16.6 Remove the solenoid valve cartridge (see
16.7 Use a flat nose pliers to pull the filter (d) out.
16.8 Replace the filter.
☞
Important!
Ensure correct installation position. The rib of the filter must not lie on the flow-through
hole.
16.9 Reassemble in the reverse order.

17. Replacing the Non-return Valve

Warning!
All non-return valves must always be replaced as a group.
Failure to observe can result in an increased bacterial load in drinking water and cause a
health risk or even risk of death.
☞
When a non-return valve is defective, the entire connector piece must be replaced. The
non-return valve is integrated in the connector piece.
17.1 Close the corner valves (c).
17.2 Trigger the valve.
17.3 Unscrew the water connector hoses (a) from the connector pieces.
17.4 Replace the connector pieces (b).
17.5 Reassemble in the reverse order.
Chapter 18.).
9