Sonnenkonig FRESCO 140 Mode D'emploi page 55

Timer operation
Timer ON setting:
• When the air conditioner is OFF, press the „Timer" (3) button and select a desired ON
time by using the temperature and time setting buttons.
• "Preset ON Time" is displayed on the operation panel.
• ON time can be set for any time in 0 – 24 hours.
Timer OFF setting:
• When the air conditioner ON, press the „Timer" (3) button and select a desired OFF
time by using the temperature and time setting buttons.
• "Preset OFF Time" is displayed on the operation panel.
• OFF time can be set for any time in 0 – 24 hours.
Swing (air flow)
• After turning on the machine, press the «swing» (2) key and the air vents will conti-
nuously swing up and down. When this button is pressed again, the movement will
stop and the air vents will remain in that position.
Sleep control function
• When in cooling mode, press the «sleep» (1) key to set the temperature. It will in-
crease by 1 °C after an hour and at most it will increase by 2 °C after 2 hours.
• Press the «sleep» (1) key again can to cancel the setting.
Drainage
• It is the alarm function if the water tank inside is filled up. The water tank in the air condi-
tioner has a wa-ter level safety switch which controls the water level. When the water level
reaches a certain height, the "water full" indicator lamp will light up. (If the water pump is
damaged and the water tank is full, please remove the rubber block at the bottom of the
device and all the water will drain out.
55
EN