Sonnenkonig FRESCO 140 Mode D'emploi page 49

mended by the manufacturing company.
– The device must be placed in an area without any continuously operating sources of
ignition (for example: open flames, gas or electrical appliances in operation).
– Do not pierce or burn the device.
– This device contains Y g (see rating label on the back of the unit) of R290 refrigerant
gas.
– R290 is a refrigerant gas that complies with the European directives on the environ-
ment. Do not puncture any part of the refrigerant circuit.
– If the device is installed, operated or stored in a non-ventilated area, the room must
be designed to prevent the accumulation of leaking refrigerant as it poses a risk of fire
or explosion if the refrigerant is ignited by electric heaters, stoves or other sources of
ignition.
– The device must be stored in such a way as to prevent mechanical failure.
– Individuals who operate or work on the refrigerant circuit must have the appropriate
certification issued by an accredited organisation that ensures competence in handling
refrigerants according to a specific evaluation recognised by the associations in the
industry.
– Repairs must be performed based on the recommendation from the manufacturing
company. Maintenance and repairs that require the assistance of other qualified per-
sonnel must be performed under the supervision of an individual specified in the use of
flammable refrigerants.
Safety Awareness:
1. Do not use the device on a socket which is under repair or not installed properly.
2. Do not use the device in the following situations:
A: Near sources of fire.
B: In an area where oil is likely to splash.
C: In an area exposed to direct sunlight.
D: In an area where water is likely to splash.
E: Near a bath, a shower or a swimming pool.
3. Never insert your fingers, sticks or similar objects into the air outlet. Take special care
with and warn children of these dangers.
4. Keep the unit upright during transport and storage so the compressor remains properly
positioned.
5. Before cleaning the air conditioner, always turn off or disconnect the power supply.
6. When moving the air conditioner, always turn it off first, disconnect the power supply
and move it slowly.
7. To avoid a fire hazard, do not cover the air conditioner.
8. All the sockets for the air conditioner must comply with the local electric safety
requirements. If necessary, please check the requirements.
49
EN