Replacing The Tail Rotor Propeller; Replacing The Vertical Tail; Checking The Screw Connections - Conrad RTF MSP190 Notice D'emploi

b) Replacing the Tail Rotor Propeller
The propeller of the tail rotor (1) is pushed onto the mo-
tor shaft (2) and can be easily removed from the shaft.
Pull off the defective propeller with the fingers and en-
sure that the motor shaft is not bent when pulling it off
and pushing it on.
c) Replacing the Vertical Tail
The vertical tail (1) is reliably held by latches (2) on the
tail boom (3). To remove the vertical tail unit, the latches
must be carefully unlatched with a small screwdriver.
The replacement vertical tail is then carefully pushed
onto the tail boom until the latches latch again secu-
rely.
d) Checking the Screw Connections
Regularly check all screw connections of your helicop-
ter for tight fit.
Particularly observe the screws (1, 2 and 3) at the rotor
shaft.
52
Figure 20
Figure 21
Figure 22