Binding Of The Model Helicopter - Conrad RTF MSP190 Notice D'emploi

12.

Binding of the Model Helicopter

Transmitter and receiver in the model helicopter are already aligned with each other (bound) in the factory and can
be used at once. Binding only needs to be performed again after replacing the transmitter or receiver or to remove
malfunctions.
Since other manufacturers use different encoding methods, transmitter and receiver cannot be combined and opera-
ted with products of other companies.
Re-establishing the binding:
To recover binding between the transmitter and receiver, the flight battery must be unplugged and the transmitter must
be switched off. The helicopter model and the remote control transmitter must be in direct proximity to each other
(max. 1 m distance).
Proceed as follows:
• Connect the flight battery to the model helicopter. The
red LED on the left side behind the canopy (1) will
start flashing quickly for approx. 5 seconds.
• While the LED in the model helicopter flashes quickly,
push the left control lever from above; keep it in this
position and then switch on the transmitter with the
on/off switch (also see figure 1, item 6).
• The transmitter emits short signal sounds and the
LED display of the transmitter (also see figure 1, item
10) lights up red and green alternatingly. During this
time, the LED in the model helicopter will flash slow-
ly.
• Release the left control lever again and wait until bin-
ding is completed after approx. 3 seconds.
• Once binding has been completed successfully, the
LEDs at the transmitter and in the helicopter light up
red again permanently and the transmitter's signal
sound goes out.
Binding is now completed and the helicopter should react to the transmitter's control signals again. If this is
not the case, repeat binding.
50
Figure 18