8.1.5
Changing the background picture
The background picture for the main display can be changed here. Five different background pictures are
available.
8.1.6
Changing the menu colour
The background colour for the menu can be set to blue, green or pink.
8.1.7
Automatic call accept
Incoming calls are accepted automatically when you lift the receiver from the base station. If you only want
calls to be accepted by means of the call button, you can deactivate the automatic acceptance facility.
8.2
Base settings
Base settings
8.2.1
Setting the base station ring tone
The base station can also respond with five different ring tones when a call comes through.
8.2.2
Ring tone volume on the base station
The volume of the ring tone on the base station can be adjusted in five steps. If at any time you do not want to
be disturbed, you can also turn the ring tone off altogether.
8.2.3
Ring priority
When multiple mobile units are used, you can specify one mobile unit to ring before the other mobile units.
You can also select the base station if you have a cord-connected telephone connected in parallel, for
example. In this case, the telephone and the base station will ring first before the mobile units. The number of
rings before the other mobile units ring can also be set. Even when a mobile unit does not ring, the incoming
call is visually signalled at the mobile unit and can also be accepted there.
8.2.4
Setting the recall mode (flash time)
If you have connected your telephone to a private exchange, you can use all the facilities such as call transfer,
automatic recall, etc. The "R" signal button gives you access to these facilities. The FLASH time "90ms"
(RECALL 1, factory Setting) or "250ms" (RECALL2) will be required on a private exchange. You can find out
from the dealer from whom the equipment was purchased whether your telephone will work on your private
exchange without any problems.
- Special functions -
Base Ringtone
Base Volume
Handset Priority
Recall Mode
System PIN
75