Subscribing A Butler 1250 Handset To A Butler 575/575+ & Cocoon100/100+ & Butler 2000 Base Unit; Subscribing A Butler 1800T Handset To A Butler 1250 Base Unit; Removing Subscription Of A Handset With A Base Unit - Topcom Butler 1250 Mode D'emploi

Butler 1250
• Press the Programming key
• The handset is subscribed to the base unit.
4.24 Subscribing a Butler 1250 handset to a Butler 575/575+ & Cocoon100/100+ &
Butler 2000 base unit
Press the Paging key
for +/- 15 seconds until you hear a beep. The base unit is now in subscribing mode. For
1 minute, the base unit is in subscribing mode and you have to do the following to subscribe
the handset:
Note: The answering machine only works with the original Butler 1250 handset subscribed to a Butler 1250
base unit!!
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number for the base unit to which you would like to subscribe the handset (1-4).
Use the number keypad.
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds once the base unit is found by the handset.
• Press the Programming key
• 'PIN' appears on the display.
• Enter the 4-digit PIN code of the base unit (default PIN code is '1590'). Use the number keypad.
• Press the Programming key
• The handset is subscribed to the base unit.

4.25 Subscribing a Butler 1800T handset to a Butler 1250 base unit

The below procedure only applies to a Butler 1800T handset and Butler 1250 base unit!!
Press the Paging key
op the base unit starts to blink quickly. The Line/Charge indicator
minute. During this minute, the base unit is in subscribing mode and you must do the
following to subscribe the handset:
• Press the key once.
• Press the OK key and select a base unit (1-4) with the
• Press the OK key.
• Enter the PIN code of your base unit. Usually: 0000.
• Press OK. The Butler 1800T now searches for your DECT base unit. As soon as it finds it, you
will see the identification code of this base unit on the display.
• Press OK to confirm your selection or press ESC to cancel the subscription.
4.26 Removing subscription of a handset to a base unit
It is possible to cancel subscription of a handset to a base unit. You would do this if a
handset is damaged and has to be replaced by a new one.
Caution: You can only cancel subscription of another handset, not the handset you are using to do the
cancellation procedure.
.
on the Butler 575/575+ or Cocoon100/100+ or Butler 2000 base unit
.
repeatedly until 'BASE SUB' appears on the display.
.
appear on the display.
.
.
on the base unit for 10 seconds until the Line/Charge indicator
93
will blink quickly for one
keys.